Yamaha TSS-1 Bedienungsanleitung Seite 7

Adjusting the front angle of the satellite
speakers
The front angle of the satellite speakers can be adjusted as
shown below.
1
Loosen the screw on the bottom of the speaker stand.
* Attach the supplied nonskid pads at the four corners
on the bottom of the stand for improved stability.
2
Adjust the speaker angle on the stand as you prefer, and
then tighten the screw.
Mounting satellite speakers on a wall
The satellite speakers can also be hung on the wall.
Fasten screws into a firm wall or wall support as shown in
the figure, and hang the slits on the rear of the speaker on
the protruding screws.
* Make sure that the screws are securely caught by the
slits.
Tapping screw (4 mm)
(Available in hardware stores)
Warning
● Each speaker weighs 0.4 kg (0.9 lbs.). Do not mount them
on thin plywood or a wall with soft surface material. If
mounted, the screws may come out of the flimsy surface
and the speakers may fall. This could damage the speakers
and cause personal injury.
● Do not install the speakers on a wall with nails, adhesives,
or any other unstable hardware. Long-term use and
vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
Pads
Min.
4 mm
20 mm
50 mm
Placing a center speaker on top of the
monitor
When placing the center speaker on top of the monitor,
remove the stand from the speaker, and attach the provided
fastener at the bottom of the speaker and on top of the
monitor to prevent the speaker from falling.
* Do not place the speaker on top of the monitor with an
inclination of more than 10 degrees.
10
10
Note
Though this speaker is a magnetically shielded type, there
may be some influence on the monitor picture depending on
the type of monitor or the placement of the speaker. In such a
case, place the speaker further apart from the monitor until
there is no influence on the monitor picture.
Mounting the amplifier unit on the supplied
stand
For improved stability, it is recommended to mount the
amplifier unit on the supplied stand with the supplied screws
as shown below.
* Attach the supplied nonskid pads at the four corners on
the bottom of the stand for improved stability.
To front
Fastener
Pads
5
E-