Adjusting Speaker Balance; Playing A Source - Yamaha TSS-1 Bedienungsanleitung

Adjusting speaker balance

This procedure lets you adjust the sound output level
balance between the front, center and surround speakers
by using the built-in test tone generator. Make this
adjustment so that each speaker output level is about the
same when heard at the listening position. This is important
for high performance of the built-in DTS decoder and Dolby
Digital decoder.
* Once you have completed this adjustment, you can
adjust the overall volume level of this system by using
only the MASTER VOLUME control.
DIGITAL
INPUT
4CH
2CH
DTS
MODE
DIGITAL
PROLOGIC TEST
MUTE
CENTER
SURROUND
SUBWOOFER
MASTER VOLUME
Active Servo
Technology
HOME THEATER SOUND SYSTEM
TSS-1
1
Set the SPEAKER MODE switch to "5CH".
2
Turn the MASTER VOLUME control fully counter-
clockwise to decrease the volume to minimum.
3
Turn on this system.
4
Set the CENTER and SURROUND level controls at
the center position.
CENTER
5
Press the TEST button.
6
Adjust the master volume to the desired level.
* You will hear a test tone (so called pink noise) from each
speaker for about two seconds in the following order.
FRONT L
SURROUND L
7
Adjust the CENTER and SURROUND level controls
while listening to the test tones so that their levels
become about the same as the front speakers'
level.
* Adjust the right-left volume balance of the front speakers
and the surround speakers by changing the position of
each speaker.
8
When the adjustment is completed, press the TEST
button.
* The test tone stops .
8
E-
DIGITAL
INPUTS
OPTICAL
SPEAKER
OUTPUTS
L
5, 8
COAXIAL
FRONT
R
L
SURROUND
4, 7
ANALOG
R
INPUTS
1
FRONT
SURROUND
2
CENTER
S. WOOFER
2, 6
SPEAKER
1 MODE
5CH
4CH
2CH
DC IN 15V
3
SURROUND
CENTER FRONT R
SURROUND R
Notes
●
When the SPEAKER MODE switch is set to "4CH":
The test tone for the center channel is reproduced from both
the left and right front speakers at the same time.
When the SPEAKER MODE switch is set to "2CH":
The test tones for the left and right surrounnd channels are
reproduced from the left and right front speakers
respectively. The output order of the test tones is as follows.
FRONT L
VIRTUAL SURROUND L
VIRTUAL SURROUND R
●
Adjust the subwoofer level while listening to playback sounds
of a source.

Playing a source

This section explains how to turn on this system and select
input sources. Before turning on this system, turn on the
external audio unit to be used.
DIGITAL
4CH
2CH
DTS
DIGITAL
PROLOGIC
CENTER
SURROUND
SUBWOOFER
MASTER VOLUME
HOME THEATER SOUND SYSTEM
1
Turn the MASTER VOLUME control fully
counterclockwise to decrease the volume to
minimum.
2
Turn on this system.
3
Select the appropriate input mode by pressing the
INPUT selector button.
* The indicator for the selected input mode lights up.
* Refer to the "Controls & connectors" on page 6 for
details about the input modes.
4
Play a source on the external unit.
5
Adjust the volume to the desired level.
6
Select a desired surround mode.
* Refer to the "Controls & connectors" on page 6 for
details about the surround modes.
FRONT R
3
INPUT
6
MODE
TEST
MUTE
1, 5
Active Servo
Technology
TSS-1
2