Knurr CoolTherm Bedienungsanleitung Seite 76

CoolTherm
Manual / Bedienungsanleitung
Very early fire detection / fire extinction
Component Function
A30:2 Goes off in case of smoke, from
pre-alarm light diffusion of 60% of the main
alarm value
(alarm = 1)
is signaled:
Web visualisation
SNMP trap
A30:4 Goes off when smoke occurs,
main alarm from 0.5% of light diffusion/m
(alarm = 1) is signaled:
Web visualisation
SNMP trap
A30:32 Internal defect of very early fire
disturbance detection
(alarm = 0) is signaled:
Web visualisation
SNMP trap
Extinction triggered When fire extinction is installed,
report when extinction has been
triggered
(message = 1)
is signaled:
Web visualisation
SNMP trap
Heat flowmeter
Component Function
B11 Temperature measurement
temperature chilled
water feed is signaled:
Web visualisation
display
SNMP
B12 Temperature measurement
temperature chilled
water return is signaled:
Web visualisation
display
SNMP
B26 Measurement of water flow
Flowmeter
is signaled:
Web visualisation
display
SNMP
CoolTherm
Assembly Connection Variables
5-DI4:1 31.1.1
5-DI4:2 32.2.1
5-DI4:3 31.1.4
5-DI4:4 32.2.4
Assembly Connection Variables
2- 49.1.1
2RTD:Ch 49.1.2
1
2- 50.2.1
2RTD:Ch 50.2.2
2
2-AI2:Ch 1 51.1.2
51.1.3
01_998_330_0_m
SNMP
rauch_valm Status check
Trap in case of
status change
rauch_halm Status check
Trap in case of
status change
rauch_fail Status check
Trap in case of
status change
rauch_glt Status check
Trap in case of
status change
SNMP
was_klt_in Value requested
Trap in the event
of falling short of
or exceeding limit
values
was_wrm_in Value requested
Trap in the event
of falling short of
or exceeding limit
values
was_flow_in Value requested
page / Seite 76/157