Knurr CoolTherm Bedienungsanleitung Seite 40

CoolTherm
Manual / Bedienungsanleitung
figure
The fan is installed in the reverse order of removal.
Tighten the fan fixing bolts.
-
Connect the power supply cable to the fan
-
Attention: Reconnect earth cable at the sheet steel cover !
-
Switch on the the fuse
-
Dispose of the old fans correctly!
Regularly inspect the heat exchanger (annually)
- Check heat exchanger on air side for soiling and damage.
Check feed and return for correct function.
-
- If necessary clean the air side.
Regularly check odour trap (external) for correct function.
-
Heat exchanger can be pulled out for improved cleaning.
-
- Regularly visually inspect the water circuit for leaks.
CoolTherm
fan change at rear door
01_998_330_0_m
Step 3:
Disconnect
supply cable
at the fan
terminal block
(unscrewing 2
screws and
remove
connector)
Step 4:
Undo the four
fastening bolts
page / Seite 40/157