Knurr CoolTherm Bedienungsanleitung Seite 61

CoolTherm
Manual / Bedienungsanleitung
Clicking onto the output Logic 2.x will take you to Logics level 2. Its default setting is configured in
such a way that the results from Logic levels 1 are passed on directly to outputs 1 to 4. Each
output must now only be enabled by means of enable out. The linked result will then be available
at the relay outputs (optional) or is sent out as an SNMP trap if trap dispatch has been enabled.
For further logical linking, proceed analog to Logic level 1.
Logic level 2
CoolTherm 01_998_330_0_m page / Seite 61/157