Cleaning - Silvercrest IAN 278383 Bedienungsanleitung

1) Remove the handheld vacuum cleaner from the wall bracket 3 or, if you are
not using the wall bracket 3 remove the barrel plug 5 from the socket.
2) If required, place the appropriate nozzle in the suction opening:
–
the crevice nozzle 2, to clean narrow and diffi cult to reach locations.
–
the wet suction nozzle 1 to vacuum up liquids.
NOTE
After you have vacuumed up liquids, immediately clean the dirt container q.
►
Otherwise, bacteria or mould will build up inside! Ensure that the dust fi lter
bag 9 is completely dry before using the appliance again.
3) To switch the appliance on, slide the on/off switch 6 forwards. The charge
indicator lamp 7 lights up green.
4) When you have fi nished using the appliance, slide the on/off switch 6 to
the rear.
NOTE
Place the handheld vacuum cleaner in the wall bracket 3 and start the
►
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp 7 fl ashes green.

Cleaning

To achieve the best results, empty the dirt container q and clean the dust fi lter 0
after every use.
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container q, press the release button 8 and remove the
dirt container q.
2) Remove the dust fi lter 0 from the dirt container q.
3) Empty the dirt container q.
4) Pull the dust fi lter bag 9 with its holder out of the dust fi lter 0.
5) Rinse the dust fi lter bag 9 out in cold water and wait until it is completely
dry before reinserting it into the dust fi lter 0. Do not dry it with hot air.
6) Reinsert the dust fi lter 0 into the dirt container q. When doing so, ensure
that the dust fi lter 0 is seated squarely and that the rubber lip seals the dirt
container q.
SAS 7.4 LI B1
│
GB 35 ■