Troubleshooting; General - Jacobsen AR-522 Handbuch

5

TROUBLESHOOTING

5 TROUBLESHOOTING
5.1

GENERAL________________________________________________________________

The troubleshooting chart below lists basic problems that may occur during start-up and operation. For more detailed
information regarding the hydraulic and electrical systems contact your area Jacobsen Dealer.
Symptoms
Engine will not start. 1.
2.
3.
4.
5.
6.
7.
Engine hard to start 1.
or runs poorly.
2.
3.
4.
Engine stops. 1.
2.
Engine overheating. 1.
2.
3.
Battery not holding 1.
charge.
Battery light on. 2.
3.
4.
Decks cut unevenly. 1.
2.
3.
18
Possible Causes
Parking brake disengaged, traction
pedal not in Neutral, or mow switch on.
Glow plug has not timed out.
Battery low on charge or defective.
Fuel tank empty or dirty.
Fuse blown.
Relay defective.
Neutral switch on traction pedal out of
adjustment or defective.
Fuel level low, fuel or fuel filter dirty.
Air cleaner dirty.
Injectors, fuel pump.
Engine problem.
Fuel tank empty.
Interlocks not set before leaving
operator's seat.
Coolant level low.
Air intake restricted.
Water pump belt broken or loose.
Loose or corroded battery terminals.
Low electrolyte.
Alternator belt loose or broken.
Charging system defective.
Height of Cut not adjusted correctly.
Engine speed too low.
Mow speed not adjusted for turf
conditions.
Action
1. Check interlock system and start-up procedure.
2. Reset ignition switch and allow glow plug to time out
before cranking engine.
3. Inspect condition of battery and battery connections.
4. Fill with fresh fuel. Change fuel filter. Bleed fuel
lines.
5. Replace fuse.
6. Test and replace relay.
7. Adjust or replace switch.
1. Fill with fresh fuel. Change fuel filter. Bleed fuel lines.
2. Inspect and replace air filter.
3. Consult Engine Manual.
4. Consult Engine Manual.
1. Fill with fresh fuel and bleed fuel lines.
2. Engage parking brake and set mow switch to OFF.
1. Inspect and add coolant.
2. Clean air intake at radiator.
3. Tighten or replace belt.
1. Inspect and clean terminals.
2. Refill to correct level.
3. Tighten or replace belt.
4. See Engine Manual.
1. Inspect height of cut adjustment. Same number of
spacers below deck housing on all spindles.
2. Check engine speed. Run engine at full throttle.
3. Adjust mow speed for best cut.