Choke Control; Specific Torque Requirements - Jacobsen Greens King IV Handbuch

4.17 CHOKE CONTROL _________________________________________________________

1. Push choke control knob to the OFF Position.
2. Set Choke lever at carburetor to OFF (butterfly
open) position.

4.18 SPECIFIC TORQUE REQUIREMENTS _________________________________________

1. Ball joints: 30 - 35 ft. lb. (40.5 - 47.2 Nm).
2. Bedknife shoe: 25 - 37 ft. lb. (34 - 50 Nm).
3. Brake drum and hub to wheel motor: 90 - 100 ft. lb.
(122 - 135 Nm).
4. Wheel mounting hardware 65 - 85 ft. lb. (88 - 115
N.m). Check and retorque daily until torque is
maintained.
5. Rear steering pulley: 50 - 60 ft. lb. (67.5 - 81 Nm).
6. Engine drain plug 22 ft. lb. (29.7 Nm).
7. ROPS:
ROPS Bracket to Frame: 40ft lb. (54.2 Nm)
ROPS Tube to Bracket: 75 ft. lb. (101.7 Nm)
ROPS Tube Plates: 30 ft. lb. (40.7 Nm)
3. Adjust control wire (at the carburetor) then clamp
wire housing in place while keeping choke butterfly
open and the control knob in the OFF position.
ADJUSTMENTS 4
21