Torsion Springs; Anti-Sway Springs; Grass Catchers - Jacobsen Greens King IV Handbuch

3.4

TORSION SPRINGS ________________________________________________________

1. Slide one clamp (F) over each lift arm and secure
with 5/16-18 x 1-1/4" carriage bolt and 5/16-18
locknut (G and E). Do not tighten.
2. Slide the right (J) and left (H) torsion spring over
their respective lift arms. Insert end of springs
between clamp ends.
3. Slide swivel housing (B) onto the lift arm and secure
housing with pin (C). Hook ends of torsion spring
over pin (C).
3.5

ANTI-SWAY SPRINGS ______________________________________________________

1. Assemble one 1/2-13 hex jam nut (L) onto rod (M)
then secure the rod to the bottom rear of frame with
1/2" lockwasher and 1/2-13 jam nut (K).
2. Assemble anti-sway spring to adjusting rod and then
the rear lift yoke.
3. Adjust anti-sway spring. [Section 4.7]
3.6

GRASS CATCHERS ________________________________________________________

Install by hanging catcher hooks on mower lift yoke and
letting catcher hang by its own weight.
Adjust as described in sheet included with grass catcher.
B
Figure 3D
SET-UP
G
F
J
E
H
C
K
L
M
3
Figure 3B
Figure 3C
11