Fuel Hose Routing; Seat; Reel Adjustments - Jacobsen Greens King IV Handbuch

3.9

FUEL HOSE ROUTING______________________________________________________

Gas Units Only
1. Remove temporary hose from fitting in top right
corner of tank to rollover valve.
2. Assemble goose neck tube (BA) to right side ROPS
tube using four clamps (BB) and #10-24 x 1/2"
thread cutting screws (BC).
NOTE: Adjust length of hoses as required to prevent
droops (hose too long) or kinks (hose too short).
3. Assemble 13 in. (330 mm) hose (BD) to fitting and
goose neck tube using two hose clamps (BE).
4. Assemble 5-1/2 in. (140 mm) hose (BF) to bottom
port of rollover valve (BG) and goose neck tube
(BA) using two clamps (BE).

3.10 SEAT ____________________________________________________________________

1. The seat belt has been assembled to the seat at the
factory. To prevent interference with hand throttle
operation, the retractable half of seat belt (AC) must
be assembled to left side of seat as shown.
If retractable half of seat belt (AC) is on right side of
seat, remove both seat belt halves. Assemble
retractable half of seat belt to left side of seat, and
latching half of seat belt to right side of seat.
2. Assemble the seat to the mower using 5/16 flat
washers, lockwashers and nuts (Z). Connect seat
switch wire harness to mower harness.

3.11 REEL ADJUSTMENTS ______________________________________________________

The bedknives have been backed off the reels to prevent
damage during shipment. Each reel must be adjusted
before the unit is ready for delivery.
1. Install any special rollers or reel attachments
following instructions included with them.
2. Set bedknife to reel adjustment. [Section 4.2, 4.3]
3. Adjust cutting height to customer specifications.
[Section 4.4]
BB
BE
BE
BD
BB
BB
BA
BC
BB
4. Level mowers. [Section 4.8]
SET-UP
BE
BG
BE
BF
Figure 3G
AC
Z
Figure 3H
3
13