Parking Brake; Interlock Switches; Reel Switches - Jacobsen Greens King IV Handbuch

4.11 PARKING BRAKE__________________________________________________________

Disengage brake lever and measure the distance
between nut (AB) and bottom of pivot. Adjust nut so the
distance is 3/16 in. (5 mm).

4.12 INTERLOCK SWITCHES ____________________________________________________

1. Refer to the Interlock System check in your Safety &
Operation manual. If the system fails any test listed,
adjustment or replacement of the switches or levers
is required.
2. Remove the front cowling and check the control
linkages to be sure they are properly adjusted
(Sections 4.11, 4.14 and 4.15).

4.13 REEL SWITCHES __________________________________________________________

The reel lever linkage actuates two electrical switches
located under the levers. Check that both switches are
closed when all reel levers are in their Neutral position.
1. Check and make sure switches are wired correctly.
Refer to Figure 4N and labels attached to wires for
correct terminal placement.
2. When any of the reel levers are moved to the
forward position, Reel Switch (Wires A and B)
should open, and Backlap Switch (Wires C and D)
should remain closed.
3. When any of the reel levers are moved to the
reverse position, Backlap Switch (Wires C and D)
should open, and Reel Switch (Wires A and B)
should remain closed.
3/16 in.
(5 mm)
AB
3. Check switches to make sure they are working
properly.
!
CAUTION
Never operate equipment with damaged switches.
Replace faulty switches immediately.
D
ADJUSTMENTS
Figure 4M
Backlap Switch
Reel Switch
A
B
C
Figure 4N
4
GKV-13
19