What To Do If The Descaling Procedure Is Interrupted; Warning Icons And Error Codes; Meaning Of The Warning Icons - Saeco PicoBaristo HD8927 Bedienungsanleitung

DESCALING COMPLETED

What to do if the descaling procedure is interrupted

ADD WATER
ADD COFFEE
13Wait until the machine stops dispensing water. The descaling procedure is
finished when the tick appears on the display.
14Press the OK button to exit the descaling cycle. The machine starts heating
up and performs the automatic rinsing cycle.
15Remove and empty the container.
16Perform the 'Weekly cleaning of the milk carafe' procedure to clean the milk
carafe after descaling.
17Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
18Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!
Once the descaling procedure has started, you must complete it till the very
end without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the standby button. If
this occurs, or in case of a power failure or accidental disconnection of the cord,
do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank up to the CALC CLEAN level indication and switch the
machine back on. The machine will heat up and perform an automatic rinsing
cycle.
3 Before brewing any beverages, perform a manual rinsing cycle, see section
'Manual rinsing cycle'.
Note: If the descaling procedure was not completed, the machine will require
another descaling procedure as soon as possible.

Warning icons and error codes

Meaning of the warning icons

Warning signals are displayed in red. Below you find a list of the warnings that
may appear on the display and their meaning.
- Fill the water tank with fresh water to the MAX level indication.
- The bean hopper is empty. Put new coffee beans in the bean hopper.
English
31