What To Do If The Descaling Procedure Is Interrupted - Saeco Incanto HD8911 Bedienungsanleitung

2
1
CALC
CLEAN
5 Pour the descaling solution in the water tank. Fill the water tank with
fresh water up to the CALC CLEAN level indication. Place the water tank
back in the machine. Press the OK button to confirm.
-
The first phase of the descaling cycle starts. The machine starts
dispensing the descaling solution at intervals.
-
The display shows the descaling icon, the phase indication and the
duration. This first phase takes 20 minutes.
6 Let the machine dispense the descaling solution until the water tank is
empty.
7 Remove the water tank and rinse it.
8 Fill the water tank with fresh water up to the CALC CLEAN level
indication. Place the water tank back in the machine and press OK.
9 Remove and empty the container and place it back under the coffee
dispensing spout. Press OK to confirm.
10 The second phase of descaling starts, which is a rinsing cycle. This phase
takes 3 minutes. The display shows the rinsing icon and the duration of
the phase.
Note: If the water tank is not filled up to the CALC CLEAN level, the
machine may require another rinsing cycle.
11 Wait until the machine stops dispensing water. The descaling procedure
is finished when the tick appears on the display.
12 Press the OK button to exit the descaling cycle. The machine starts
heating up and performs the automatic rinsing cycle.
13 Remove and empty the container.
14 Clean the classic milk frother after descaling. (see 'Weekly cleaning of
classic milk frother and steam wand ')
15 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
16 Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

Once the descaling procedure has started, you must complete it till the very
end without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the standby button.
If this occurs, or in case of a power failure or accidental disconnection of the
cord, do the following:
1 Switch off the machine.
2 Empty and rinse the water tank thoroughly.
3 Fill the water tank up to the CALC CLEAN level indication and switch the
machine back on.
-
The machine will heat up and perform an automatic rinsing cycle.
4 Before brewing any beverages, perform a manual rinsing cycle (see
'Manual rinsing cycle').
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.
English
27