Machine: Every 600 Working Hours - Ransomes Commander 3520 Bedienungsanleitung

8 LUBRICATION AND MAINTENANCE
LUBRICATION

8.3 MACHINE: Every 600 Working Hours.

Change Hydraulic Oil
1. Remove drain plug in bottom of Hydraulic tank
and wipe off plug.
2. Allow tank to drain and replace plug.
3. Refill tank with approx. 52 litres of Shell Tellus 46
Oil.
4. Hydraulic Oil should be filled to level indicated by
sight glass. (C Fig.8.3.1)
IMPORTANT-Whenever the closed loop transmission
circuit has been broken into, it is essential that the
circuit is flushed prior to use. Absolute cleanliness
must be observed when filling the hydraulic tank.
Oil must be filtered through a 25 micron filter before
entering the hydraulic tank.
Change Hydraulic Oil Filter (SUCTION) (A Fig.8.3.2)
1. Wipe filter canister and housing to remove any dirt
present.
2. Place a suitable drip tray under the filter.
3. Unscrew filter and dispose of safely.
4. Replace with new filter canister.
5. Coat the top outside lip of the filter canister with a
thin film of oil and refit the filter canister.
6. Filter should be replaced before refilling hydraulic
tank.
Change Hydraulic Oil Filter (CHARGE) (A Fig.8.3.3)
1. Wipe filter canister and housing to remove any dirt
present.
2. Place a suitable drip tray under the filter.
3. Unscrew filter canister and remove the filter
element and dispose of safely.
4. Replace with new filter element.
5. Coat the top outside lip of the filter canister with a
thin film of oil and refit the filter canister.
6. Filter should be replaced before refilling hydraulic
tank.
SAFETY, OPERATORS & MAINTENANCE MANUAL
RANSOMES COMMANDER 3520
Fig.8.3.1
Fig.8.3.2
Fig.8.3.3
GB-33