Automotive Functions - Ransomes Commander 3520 Bedienungsanleitung

6 CONTROLS

6.18 AUTOMOTIVE FUNCTIONS

Analogue Display
A. Charge warning lamp Colour red, on when
ignition is switched on and will go out once
engine has started. If the lamp comes on
when the engine is running, the fan belt
may be slipping or broken or a fault in the
electrical system is indicated and should
be investigated STOP IMMEDIATELY.
B. Engine oil pressure warning lamp Colour
red, on when ignition is switched on, and
will go out once the engine has started. If
the lamp comes on when the engine is
running STOP IMMEDIATELY as this
indicates that the oil pressure is to low.
Check the level of oil in the engine sump
and if necessary top up. Check oil
pressure switch. Continued operation may
cause extensive damage to the engine.
C. Engine overheat warning lamp Colour red,
this lamp will come on when the engine
temperature reaches a pre-set level. The
vehicle horn will sound simultaneously. If
the lamp comes on or the horn sounds
STOP IMMEDIATELY and investigate the
cause. The lamp will come on during
engine preheat for checking purposes
only.
Note: This warning lamp works independently
of the engine coolant temperature gauge.
E. Glow plug warning lamp Colour red, this lamp is
timed on for a period of approximately five seconds
when the ignition switch is turned clockwise to the
preheat position. Once the lamp has gone out the
engine can be started. This warning light is also
used to indicate a blocked charge filter.
SAFETY, OPERATORS & MAINTENANCE MANUAL
MACHINE SWITCH STATUS
F. Mow switch status indicator Colour
yellow, on when the cylinder drive is
engaged, off when the cylinder drive is in
neutral.
H. Seat switch status indicator Colour yellow,
on when the seat is not occupied, off when
the seat is occupied.
Note: The engine can not be started if any of
the machine status indicators are on. The
machine status indicators will continue to
indicate switch status when the machine is
being used.
RANSOMES COMMANDER 3520
GB-21