Safety Catches - Ransomes Commander 3520 Bedienungsanleitung

6 CONTROLS
6.14 SAFETY CATCHES (A)
When transporting, the safety catches should
always be engaged with the units raised. These
units can be hydraulically locked in any position by
releasing the lift control lever at the required position.
To secure the front and wing units in the transport
position the hooks on the frame should be rotated to
trap the spigots on the lift arms. The rear (centre)
unit is held in the transport position by a catch
which is operated by a hand lever situated under the
left hand step behind the front wheel. To lock the
unit in its raised position, pull lever out and down in
the gate.
WARNING
Cutting Unit Transport Latches are a
Secondary Safety Devise.
When Transporting the machine the
Cutting units should be held in the
Transport position on the Hydraulics with
the Transport Latches Engaged.
1. Park the machine on level ground.
2. Whilst seated in the driving position
With the engine at operating speed
raise the cutting units fully by
operating lift levers, return the lever to
the neutral position.
DO NOT move the lever into the
lower position.
3. Disengage drives, stop the engine and
make sure all moving parts are
stationary. Apply brakes and remove
the starter key.
4. Transport latches can now be engaged
or released.
Before releasing transport latches
it is important that all cutting units
are fully raised.
GB-16
SAFETY, OPERATORS & MAINTENANCE MANUAL
RANSOMES COMMANDER 3520