Stand-Alone Operation; Control Board; Password Lock - EuroLite LED MFX-9 Beam Effect Bedienungsanleitung

Stand-alone operation

In the Stand-alone mode, the LED MFX-9 Beam Effect can be used without controller.
Disconnect the LED MFX-9 Beam Effect from the controller and call up the internal programs. Please refer to
the instructions under Control Board.

Control Board

The Control Board offers several features: you can easily set the starting address or run the pre-
programmed program.
Press MODE to access the menu on the display. Browse through the main menu by pressing UP or DOWN.
Press ENTER in order to select the desired menu. You can change the selection by pressing UP or DOWN.
Press ENTER in order to confirm. You can leave every mode by pressing MODE. The functions provided are
described in the following sections.
The display shuts off after 15 seconds of inactivity. With the touch of a button it lights up again.
Default settings shaded.
Menu
MENU 1:
DMX 512
MENU2:
TEST
Master-Mode
MENU3:
AUTO
Master-Mode
MENU 4
OPTION
MENU 5:
PASSWORD
MENU 6:
RE-DEF-
MENU 7:
RESET
Sub menu
DMX512
49CH: xxx, 001
DMX512
22CH: xxx, 001
DMX512
13CH: xxx, 001
Setting DMX channel mode (49CH, 22CH, 13 CH, 11CH,
DMX512 8CH or 5CH) and DMX starting address (001 - 512)
11CH: xxx, 001
DMX512
8CH: xxx, 001
DMX512
5CH: xxx, 001
TEST
CH01: xxx, 000 Test function of the respective channels
T (CH01-CH49, values 000 - 255), see also DMX protocol
CH49: xxx, 000
AUTO Internal programs 1-9
MAUTO: x, 7 with horizontal movement (PAN)
AUTO Internal programs 1-9
AUTO: x, 7 without horizontal movement (PAN)
AUTO Sound controlled internal programs 1-9
MSOUND: x, 7 with horizontal movement (PAN)
AUTO Sound controlled internal programs 1-9
SOUND: x, 7 without horizontal movement (PAN)
AUTO Manual adjustment of the PAN angle (0-255),
PAN: xxx, 000 (only available for AUTO: x and SOUND: x)
PAN-Setting
OPTION
No: PAN setting clockwise
PAN: No
Yes: PAN setting anticlockwise
OPTION Sensitivity setting for sound control
Sound: xxx, 128 0 – 255 with increasing sensitivity
PASSWORD Turn off password protection.
UNLOCK Default setting = 988
PASSWORD Turn on password protection.
LOCK Default setting = 988
Function
Restore factory settings
Reset
32/44 00103748.DOC, Version 1.0