Master/Slave Operation; Operation; Stand Alone Operation - EuroLite LED PAR-64 RGBAW 49x3W Short Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Please refer to the instructions under Control Board.

OPERATION

The device has two operating modes. It can be operated via the Control Board or it can be run in DMX-
controlled mode via a DMX controller.
After you connected the effect to the mains, the LED PAR-64 RGBAW 49x3W Short starts running.
The device features a built-in microphone and a rotary control on the rear panel to adjust the sound
sensitivity.

Stand Alone operation

In the Stand Alone mode, the LED PAR-64 RGBAW 49x3W Short can be used without controller. Disconnect
the LED PAR-64 RGBAW 49x3W Short from the controller and call the internal program.
Please refer to the instructions under Control Board.
19/22 00061815.DOC, Version 1.0