Connection With The Mains; Operation; Stand Alone Operation; Control Via Dip Switches - EuroLite LED BAR-252 RGB 10mm Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED BAR-252 RGB 10mm starts running. This
unit has two operating modes. It can be run as a Stand Alone-unit or DMX-controlled.

STAND ALONE OPERATION

In Stand Alone Mode you can use the LED BAR-252 RGB 10mm without a controller.

Control via Dip Switches

You can choose from the following operational modes: Internal Programs, Auto, Sound Control, Slave,
and DMX (see following graphic).
International
L
N
20/24 00026099, Version 3.1