Faytech 7 capacitive Bedienungsanleitung Seite 24

4. Display tab
If you selected "Support Multi-Monitor System" when
you installed the Touch driver, you will see a Display
tab when you run the Configure utility. If you did not
select this option, you will not see a Display tab. You
can have up to 8 (under Widows 10) faytech touch-
screens connected simultaneously (Win XP with 2
monitors, Win 7 with 4 monitors, from Win 8 with 8
monitors). You can also use a (non-touch) display and
a touch screen. In the example below, the touch-
screen is display "2", while the second display "2" is a
normal monitor. Both have the same resolution, but
the normal display is the primary monitor.
Enable multiple-monitors: When this function is
disabled, the touch screen will be mapped to the
primary monitor automatically. When this function is
enabled, you can double click on the monitor area in
the monitor geometry window to assign the monitor
area where the touch screen will be mapped. Double-
tap on the desired monitor and answer the question
in the pop-up window with Yes.
After confirmation, your touches on the selected
touch monitor will be simulated as mouse clicks. If the
function "Map to main display if system has only one
display monitor" is activated, the program
automatically puts the touch function on the primary
monitor, if only one monitor is connected.
Since a capacitive touch monitor is optimal calibrated.
We suggest you not to do anything in the
tab Operation Mode.
5. Edge Compensation tab: fine adjustment of the
touch area
On this tab you can finely adjust the touch area. This is
very useful when you have problems touching at the
edges of the touch screen. In the following image you
can see that the limits for all edges of the screen were
corrected (to 110%). E.g. if you have problems in the
upper right area, just increase the upper and right
limit (» Bigger). Confirm the change and try the new
settings with the Draw Test. You can also use the X-
axis and Y-axis displacement options to compensate if
your touch always seems to be off the same amount
in the X and/or Y directions. The Support Edge
Compensation option optimizes the touch detection
in the corners of your faytech touch panels. This
option should always be enabled.
6. Hardware and About tabs:
The last two tabs are for information only - there are
no options to select on these tabs.
24