Faytech 7 capacitive Bedienungsanleitung Seite 23

Enable Constant Touch: is the function to check to
enable the driver to determine if the most recent
touched position is the same as the previously
touched point. If the difference is smaller than the
defined area, the driver does not generate any mouse
movement which helps reduce system load.
Enable Auto Right Click: If the touch screen is touched
for a specified time, the driver will generate a mouse
right button click if this function is enabled.
Enable Touch: Be careful! If you don't check this box,
the touch function will not work! Enable Cursor
Stablization: A software filter exists inside the driver
to filter some noise to stabilize and smooth the touch
points. When activated, the user will experience a
more stable cursor.
You can adjust the parameter for the Constant Touch
Area function. This is a criterion to judge if the most
recent touched point is the same as the previously
touched point. If the difference between the two
points is within this area, it will be recognized as the
same touch point and the driver does not generate a
new mouse event for this touch point.
You can adjust the Auto Right Click Time function. If
the touch screen is touched and held for this period of
time, the driver generates a right mouse click.
3. Tools tab:
Since a capacitive touch monitor is optimal calibrated.
You do not need to do any calibration.
The Draw Test function is used for accuracy and
performance checking. Press this button and a new
pop up window will be popped up on the monitor (see
below). Touch or drag your touch pen or finger on this
grid to gauge the effectiveness of the settings and
calibrations that you have made. If you are using your
finger, you may have to press firmly to draw
continuous lines. Press the Clear button to clear the
window. Press the Quit button to terminate this draw
test.
23