Using Egalaxtouch - Faytech 7 capacitive Bedienungsanleitung

11. The installation will be started automatically with
the selected settings. And then you will see the
following windows:
The installation is successfully completed. If you open
"eGalaxTouch", you will see the following window:
If the USB controller icon is not showing, please
disconnect the USB cable from your PC and connect it
again. For more help, please go to the
Troubleshooting section.
Remark: You can uninstall this touch tool at any time
if you want to use the gesture control again.
U G T
SING E ALAX OUCH
There is no great difference between eGalaxTouch
under Windows and Linux.
Start the administration program (under Windows 10)
by going to "Start – all apps – Configure Utility". Or
you can find this program in the system tray section of
your task bar.
1. General tab
Gives information on whether one or more touch
controllers are found and installed.
After the initial installation, if no touch controller
shows up on this tab, please pull out the USB
connector on your PC and connect the device again.
We suggest you to map all the monitors at the
beginning.
Under Monitor Mapping the Windows can recognize
every monitor. We advise you to map the monitors at
the beginning and then set up other properties of the
touch function, so that you will have a better
experience by using the touch monitor. You will see
21