Bluetooth® Operation - Renkforce BSD-3023 Bedienungsanleitung

Operation
Bluetooth® Operation
To enable best phone reception and keep the electromagnetic radiation in the vehicle as low
as possible, an outside aerial should always be used for mobile phone operation.
For the mobile phone to automatically take incoming calls, automatic call answering must be
activated at the SD tuner (see hands-free system menu) as well as in the mobile phone (see
corresponding instructions). This is a prerequisite for legal operation of hands-free systems
while driving in many countries.
In Bluetooth® operation, the SD tuner can be used as a hands-free system for mobile phones and/or as a playback
device for Bluetooth®A2DP audio streaming. However, before transmission between your mobile phone or
Bluetooth® device and the SD tuner is possible, both devices must be coupled. This process is called "Pairing".
Pairing
• Switch on your Bluetooth® device and activate pairing mode here (for this, see the instructions for the respective
device). The device then searches for Bluetooth® devices in the reception range.
• Keep the button PAIR / MOD (12) pressed until the display indicates PAIRING.
• If the SD tuner was found, your Bluetooth® device will indicate CarBT.
• Enter password 0000 to couple the two devices.
• After successful pairing, the display indicates the Bluetooth® icon
• If pairing was not successful, try repeating the process. The CarBT device in your mobile phone may have to be
deleted (see mobile phone instructions).
• Only the rotary control VOLUME (4) and the button
locked during pairing.
• To interrupt pairing prematurely, keep the button PAIR / MOD (12) pressed. The display indicates PAIR END.
78
.
/ MUT (1) will work during pairing. All other buttons are
Operating Instructions

English