Renkforce BSD-3023 Bedienungsanleitung Seite 72

Operation
• Setting the RDS Parameters
To set the RDS parameters, first keep the button 9 / PTY (9) pressed (>2 seconds) and then press it again briefly
until the desired function appears in the display.
The options for the respective setting are selected by turning the rotary control VOLUME (4).
The following settings are possible:
TA SEEK/ALARM
TA SEEK: When losing the traffic programme information, the device will automatically find a new station with
traffic programme ID.
TA ALARM: The device emits a warning sound if the traffic programme ID is no longer received.
PI SOUND/MUTE
Device reaction if you reach an area where 2 different stations with different programme identification (PI) are
transmitting the same AF (alternative frequency):
PI SOUND: The radio switches to the new station for a few seconds and then back again.
PI MUTE: The new station is muted.
RETUNE L/S
RETUNE L: If no traffic programme ID is received anymore, automatic search starts after 90 seconds.
RETUNE S: If no traffic programme ID is received anymore, automatic search starts after 30 seconds.
MASK DPI/ALL
Device reaction at station search:
MASK DPI: Alternative frequencies with different programme information (PI) are not considered.
MASK ALL: Alternative frequencies with different programme information (PI) and alternative frequencies with a
high signal strength but without RDS information are not considered.
72
Operating Instructions

English