Insertion/Replacement Of The Remote Control Battery - Renkforce BSD-3023 Bedienungsanleitung

Electrical Connection

Insertion/Replacement of the Remote Control Battery

Observe correct polarity when inserting battery.
Do not let batteries lying around openly; there is a danger that they are swallowed by children
or pets. If swallowed, see a doctor immediately.
Leaking or damaged batteries may cause caustic burns when touching skin. Therefore, use
suitable protective gloves in this case.
Ensure that the battery is not short-circuited or thrown into fire. It also must not be recharged.
There is a danger of explosion.
Remove the battery if you do not use it for an extended period of time.
• Take the remote control from the steering wheel holder as described above.
• Slide open the battery compartment lid at the rear of the remote control and remove it.
• Put in a new 3V lithium button cell CR2025 in the correct polarity. The positive pole of the battery must point
upwards for this.
• Close the battery compartment again. The latching tab must latch audibly.
• Attach the remote control in the steering wheel holder again as described above.
• If the remote control no longer works properly, the battery is discharged and must be replaced with a new battery
of the same type.
• The battery is changed as described above.
• Replace the discharged battery with a new battery of the same type.
62
Operating Instructions

English