Safety Devices; Cleaning; Connecting The Unit; Electric Connection - Daikin LBBWH Installations- Und Bedienungsanleitung

ATTENTION
Check that the unit and its devices have suffered no damages during transport. Pay
special attention to the componentssecured to the electric panel door and to the
refrigerating circuit pipes. Mount the unit as shown in the drawings; make sure that
the
electric connections are carried out properly.
6.7

Safety devices

mechanical safety devices
The following
1. Fixed upper and side protections for evaporator and condensing unit, secured by locking screws.
2. External fan protections placed on the evaporating and condensing units, secured with screws.
electrical safety devices
The following
a. Protection of fans (belonging to motors) against high power absorption; with automatic reset.
b. High pressure switch (only for special components) to protect against excessive pressure; with
automatic reset.
WARNING
Above devices have been developed to safeguard the operator's safety.

6.8 Cleaning

Clean the unit carefully. Remove any dust, foreign substances and dirt possibly deposited during handling. Use
detergents and degreasers.
ATTENTION
Solvents are not allowed.
7

CONNECTING THE UNIT

ATTENTION
Before connecting the unit make sure that mains voltage and frequency correspond
to the values shown in the data plate. Voltage tolerance: +/- 10% compared to
nominal value.
7.1

Electric connection

Connect the unit after checking the panel components.
ATTENTION
Connection to the electric line shall be effected applying a suitable safety device (a
circuit breaker or a ground fault interrupter) selected by the installer on the basis of
the line involved and of the absorption indicated on the unit plate.
If a cold room includes more units, each unit shall be provided with its own safety device.
Connect the unit paying attention to the colours of the supply cable wires:
are supplied:
are supplied:
2
1
1