Electric Controls; Control Panel - Daikin LBBWH Installations- Und Bedienungsanleitung

8 ELECTRIC CONTROLS

8.1 Control panel

Each LED function is described in the following table.
LED
Led 4
LED 3
LED 3
LED 2
(temp)
(umid)
Temperature Display
Humidity Display
MODE
ON - ALARM signal
ON - Instrument in stand by.
- In "Pr2" indicates that the parameter is also
present in "Pr1".
ON °C
ON The compressor is running
FLASHING - Anti-short cycle delay enabled
ON The defrost is enabled
FLASHING Drip time in progress
FLASHING Programming Phase (flashing with LED3)
ON Heating enabled
FLASHING Temperature Set programming phase
ON Fan is running
ON RH%
ON Dehumidifying enabled
ON Humidifying enabled
FLASHING Humidity Set programming phase
To display and modify target temperature set point.
(SET_TEMP)
To display and modify target humidity set point (SET_RH);
in programming mode it selects a parameter or confirm an
operation.
In programming mode it browses the parameter codes or
increases the displayed value.
In programming mode it browses the parameter codes or
decreases the displayed value.
By holding it pressed for 3s the defrost is started..
Switch ON and OFF the instrument.
LED2 LED3
LED4
FUNCTION