General Information; Safety Advice; Transportation; Connection Of Other Transmission Components - Sumitomo FINE CYCLO Betriebsanleitung

1 . G e n e r a l i n f o r m a t i o n
Please observe the following warnings
I m m i n e n t d a n g e r
Misapplication of the machine may be dangerous and lead to severe injuries
D a n g e r o u s s i t u a t i o n
Risk of physical injury
D a m a g i n g s i t u a t i o n
Risk of machine damage.
H e l pf u l i n f o r m a t i o n
Disposal
Please observe legal /environmental regulations.
Ex
Important remarks for explosion protection
2 . S a f e t y a d v i c e
Do not attempt to install or operate the FINE CYCLO reduction assembly until all of these instructions
on assembly, operation, maintenance and inspection and hazards are read and thoroughly under-
stood. Please keep these instructions next to the unit in operation to check at any time when neces-
Transportation, assembly, lubrication, operation, maintenance and inspection should only be done by
qualified personnel, so as to avoid personal injury or damage to property.
Do not touch moving mechanical components and make sure these parts are clear of obstructions.
Failure to follow these instructions may result in personal injury, unit failure or damage to property.
Only operate the unit in the application it was intended. Misapplication may result in physical injury or
damage to machinery.
3 . Tr a n s p o r ta t i o n r e c o m m e n d a t i o n s
The units must be checked for any transportation damage immediately upon receipt. Any damages
should be reported to the carrier without delay. If there is any evidence of damage which may put at
risk the function of the FINE CYCLO reduction assembly, do not install the unit.
4 . C o n n e c t i o n o f o t h e r t r a n s m i s s i o n c o m p o n e n ts
In the case of speed reducers with hollow high speed shafts, MoS
to be applied to the motor shaft before it is connected.
Clutches, discs, gear wheels, chains, etc. should be mounted on the reducer shafts carefully.
Do not force them onto the shafts as this could damage the gearbox bearings.
FC_GB_01_05 NO.991051
F I N E C Y C L O O p e r a t i n g M a n u a l
Issue: 01/05
paste or spray (e.g. Molykote) is
2
page 2