Makita EM4350RH Originalbetriebsanleitung Seite 20

STOPPING
1) Release the throttle lever (β) fully, and when the engine rpm has lowered, set
the Iάτ switch (1) to STτP the engine will now stopέ
β) The cutting tool continues to rotate a while after stopping the engineέ Wait until
it stops completelyέ
ADJUSTMENT OF IDLE SPEED
When it is necessary to adjust the idle speed, perform it by the carburetor adjusting screwέ
CHECKUP OF IDδE SPEED
Set the idle speed to γ,ίίί min
●
If it is necessary to change the idle speed, use a phillips head screw driver on
the screw illustrated on the rightέ
To increase the idle speed, turn the adjusting screw clockwiseέ
●
To reduce the idle speed, turn the adjusting screw counterclockwiseέ
The carburetor is factory adjustedέ ώowever, after several use the idle speed
●
need to be reάadjustedέ
PREVENTION FROM CARBURETOR ICING
CAUTIONμ
When environmental temperature is higher than 1ί°C, always return
●
the shutter to normal (sun mark) settingέ τtherwise the engine may be
damaged by overheatingέ
When the environmental temperature is low and humidity is high, water vapor
may freeze inside the carburetor and the engine drives unsteadily (carburetor
icing)έ Change the setting of the shutter as follows if necessaryέ
1έ Remove the screw (1)έ
βέ Change the direction of the shutter (β) as followsμ
Environment temperature is higher than 1ί°Cμ Set the shutter in normal
●
position (sun mark)έ
Environment temperature is equal or lower than 1ί°Cμ Set the shutter in
●
antiάicing position (snow mark)έ
γέ Tighten the screwέ
Downloaded from www.Manualslib.com
έ
–1
manuals search engine
(2)
βί
STOP
(2)
(1)
(1)