Makita EM4350RH Originalbetriebsanleitung Seite 19

η) Recoil starter
εake sure you have a irm footingέ
ώold the unit with your left hand and press it down irmlyέ
CAUTIONμ
Do not stand or kneel on the throttle cableέ The internal wire may
●
be pulled and the cutting tool may start rotating unintentionallyέ
Do not open the throttleέ
Pull the starter knob gently until a certain resistance is feltέ Then, return the
starter knob, and pull it stronglyέ
σever pull the rope to the full extensionέ τnce the starter knob is pulled, never
release your hand immediatelyέ ώold the starter knob until it returns to its
original pointέ
θ) Choke lever
τnce engine starts, set choke lever to the τPEσ positionέ
τpen the choke lever gradually while checking the engine operationέ Be
●
sure to open the choke lever to the full in the endέ
In cold or when the engine is cooled down, never open the choke lever
●
suddenlyέ τtherwise the engine may stopέ
ι) Warmάup operation
Continue warmάup operation for β to γ minutesέ
NOTICEμ
Do not pull the throttle lever unnecessarily while the engine is not
●
running. It may cause fuel leak from the air cleanerέ If it happens, wipe
leaked fuel offέ Also, open the air cleaner cover and clean the element
and the air cleaner plateέ
NOTEμ
Do not pull the throttle lever unnecessarily when the engine is not runningέ It may cause looding of fuel in the engine, and may cause the
●
engine dificult to start upέ
In case of looding of the fuel, remove the spark plug and pull the starter handle slowly to remove excess fuelέ Also, dry the electrode section
●
of the spark plugέ
If the engine ires and stops, or stops soon after starting, return the choke lever to the τPEσ position, and pull the starter knob a few times
●
again to start the engineέ
If the choke lever is left in the CδτSE position, and the starter knob merely pulled repeatedly, too much fuel will be sucked in, and the engine
●
will become dificult to startέ
Do not race the engine in warmάup operation unnecessarilyέ
●
Bμ Warm start
1) Keep the choke lever full openέ
β) Push the primer pump repeatedlyέ
γ) Keep the throttle lever at the idling positionέ
ζ) Pull the starter knob stronglyέ
You can also restart the engine while carrying the tool on your backέ
CAUTIONμ
εake sure that the cutting tool is not touching while restartingέ
●
Do not pull the throttle lever when restartingέ τtherwise the cutting tool
●
starts rotatingέ
ώold the handle with your right hand, and pull the starter knob stronglyέ
Downloaded from www.Manualslib.com manuals search engine
1λ