Setting & Data View; Tx Display - GRAUPNER mx-10 HoTT Set Programmierhandbuch

Telemetry
The menus grouped together under the overall heading
"Telemetry" are called up with the optional available
Smart-Box
Install the SMART-BOX at the mounting bracket of the
transmitter fi gure. Connect the box then the 3-pin lead to
the transmitter. Put one end of the cable into the DATA
jack on the transmitter and the other into the jack on the
right side of the SMART-BOX. The connector system is
polarised, look for the small camfer on the edges. Never
use force - the plug should engage easily and fully. The
sockets are labeled accordingly: black wire (-), red wire
(+) and orange wire (S).
Basic menu operation
In general terms the "Telemetry" menu is operated with
the four buttons on the top of the Smart-Box. You can
switch between the individual pages of the Telemetry
menu using the ESC and ENTER buttons: you will fi nd
corresponding direction indicators at top right of every
screen page in the form of angle brackets (< >); see
illustrations. If only one angle bracket is visible, then you
are currently at the fi rst or last page. In this case it is
only possible to switch pages in the direction indicated
by the angle bracket.
Menu lines in which parameters can be altered are
marked with an angle bracket prefi x (>). Pressing the
buttons INC and DEC causes the ">" pointer to jump
forward or back by one line. Lines to which you cannot
jump contain no user-variable values.
If you wish to change a parameter, press the
button simultanously to highlight the parameter (black
background)). Change the value within the possible
range using the INC or DEC buttons, and then press the
114 Program description: Telemetry menu
SETTING & DATA VIEW
INC+DEC button again briefl y to accept the value. Press
the ESC button to return back to starting position.
SETTING & DATA VIEW
MENU SETTING AND DATAVIEW
On the fi rst screen page of the sub-menu "Setting &
Data View", headed ...
TX
... only partially adjustments can be made. This page
provides information to the general transmitter settings:
TX
ACTION
MAXIMUM VOLT:
MINIMUM VOLT:
ALARM
COUNTRY
RANGE TEST : OFF 90s
INC+DEC
Display
ACTION
VOLT
MAXIMUM
VOLT
MINIMUM
VOLT
ALARM
VOLT
VOLT: 05.4V
05.5V
05.4V
VOLT: 04.7V
: GENERAL
COUNTRY
RANGE
TEST
Transmitter low-voltage warning (ALARM VOLT)
you can adjust the low voltage threshold at which the
alarm (continuous beeping) is triggered; the available
range is 4 - 15 V - factory default setting 4.5 Volt.
When the alarm is triggered, "VOLT-E" fl ashes at top
right in the SMART-BOX transmitter display, and the
parameters ACTION VOLT and ALARM VOLT are
displayed in inverse form.
Description Setup
Current operating -
voltage (V)
Maximum -
operating voltage
(since the last
power on - V)
Minimum -
operating voltage
(since the last
power on - V)
voltage setup for 4 – 15 V in steps of
transmitter low 0.1 V
voltage warning Factory setting
beep 4.5 V
Country setting GENERAL /
FRANCE
indicates if the OFF / ON
range test is
engaged, the
remaining
time also appears