Model Helicopters; Receiver Socket Sequence - GRAUPNER mx-10 HoTT Set Programmierhandbuch

Model helicopters

The continued development of model helicopters and
helicopter components, such as gyros, speed governors,
rotor blades etc., has led to the current position where
helicopters are capable of sophisticated 3-D aerobatics.
Model helicopters can be operated with the mx-10
HoTT only with stabilizer-free systems „fl ybarless", for
example V-Stabi or Microbeast be operated. This system
mixes it all for the swashplate and tail rotor necessary
servos.
The motor is controlled by switching channel 5.
For the connection of the servos for your fl ybarless
system refer to the related manual.
If the telemetry function of the receiver is used, the
motor control must be switched to channel 6 using the
optional Smart Box (see page 117 channel mapping) in
order to connect the telemetry sensors on channel 5.
All menus which are relevant to model helicopters are
marked with a "helicopter" symbol in the "Program
descriptions":
This means that you can easily skip irrelevant menus
when programming a model helicopter.
Channel 5
Installation notes
The servos will be connected to the receiver outputs
in the order shown on this page:
Outputs not required are simply left vacant.
Please note the additional information of your
fl ybarless system.
Receiver assignment for model helicopters ...
... with fl ybarless system
Motor
free or throttle (Channel Mapping
with optional Smart-Box)
Telemetry sensor or throttle
Tail rotor servo (Gyro system)
Pitch servo
Roll servo
Pitch- or Roll-2
servo
Model helicopters 103