Digital Trims And Stick Calibration; Description Of Function - GRAUPNER mx-10 HoTT Set Programmierhandbuch

Digital trims and stick calibration

Description of function

Digital trims with visual and audible indicators
Both the dual-axis stick units are fi tted with digital trim
systems. When you give the trim lever a brief push (one
"click"), the neutral position of the associated stick chan-
nel changes by one increment. If you hold the trim lever
in one direction, the trim value changes continuously in
the corresponding direction with increasing speed.
The degree of trim offset is also "audible", as the pitch of
the tone changes to refl ect the setting. When you are fl y-
ing a model, you can fi nd the trim centre position easily
without having to look at the screen: if you over-run the
centre setting, the trim stays in the centre position for a
moment.
The current trim values are automatically stored.
The digital trim only works when the transmitter is swit-
ched ON. When switched OFF, even an accidental touch
of the trim lever does not change the set values.
100 Digital trims
Stick Calibration
If you suspect that the centre point of your self-centring
sticks (transmitter controls 1 ... 4) does not correspond
exactly to 0% travel of the transmitter control, you can
check and - if necessary - correct it using the following
procedure:
Turn OFF the transmitter, and insert the supplied pro-
gramming plug into the DATA jack on the back and the
jumper in position „DELTA" on the front of the transmit-
ter. Bring both sticks in the middle position. Turn the ra-
dio ON. The transmitter starts beeping after one second
for 10 seconds once per second. During this 10 seconds
move both control sticks to all the end positions, so that
the transmitter can save this positions. After expiration
of the 10 seconds the calibration is completed and
the transmitter is back in the normal mode, the beeps
become silent. Turn the transmitter off and then remove
the programming plug on the back.
Do not use the remote control with programming
connector plugged in!
If necessary, plug the jumper into the correct positi-
on for your model.
If you have achieved not all stick-end positions during
these 10 seconds, repeat the entire process.