Brief Instructions - Siemens SIPART PS2 Kurzanleitung

Electropneumatic Positioner SIPART PS2
23
88,5
fig. 2 Dimension drawing of plastic housing / pneumatic connection
fig. 3 Pneumatic connection
6 Electric connection / technical data:
Connection:
Cable inlet:
Potentiometer: Resistance:
Maximum Power:
Valves: Switching Voltage:
capazitive Load:
slopesteepness:
Temperature range:
Fitting the cable: 1. Isolate the cable as shown in fig. 4
2. Open the positioner housing by undoing the four cover screws.
3. Feed the prepared bus cable through the screw-type cable gland.
4. Tighten the screw-type cable gland.
5. Connect the wires as shown in fig. 5
6
50 x 4 x M6
9 tief
M8
58
182
8
h9
1
7
38,5
Positioning pressure Y1 for single and double-acting actuators
Feedback shaft
Inlet air Pz
Positioning pressure Y2 for double-acting actuators
Outlet air with silencer on the underside of the instrument
Screw terminals 1.5 mm
M20 x 1,5
10kΩ
1W
±24V
100nF
300V/ms
-30°C bis +80°C
6DR59x0–0NG00-0AA0
Alle Luft-
Anschlüsse
G 1/4"
M20 x 1,5
2

Brief Instructions

11,2
A5E00196467-01