Using The Camera In Time Lapse Mode (Tls); Pre-Take Function - Sygonix 1527819 Bedienungsanleitung

c) Using the camera in time lapse mode (TLS)
• Open the base cover (7) and set the TEST OFF CAM PSET switch to CAM or PSET.
• After approx. 30 seconds, the countdown starts and the blue test LED flashes for approx.
60 seconds. Leave the detection area.
• After the 60-second countdown, the camera switches to time lapse mode. The camera begins
recording when motion is detected.
Make sure that the camera is in TLS mode. Refer to chapter 12., section c) "Setting
image or video recording" if you are not sure.

14. PRE-TAKE function

The PRE-TAKE function was designed specifically for surveillance purposes. The feature is only
available when the device is connected to an external AC adapter. Remove batteries before
connecting an AC adapter.
Any time-out settings will be ignored when you activate the PRE-TAKE function and the camera
will record images or video without a time-out period. As soon as motion detection is active, the
camera records according to the programmed settings. The recordings are triggered via motion
detection (PIR mode) and saved to the SD card.
To save power in PRE-TAKE mode and to prevent the IR LEDs from overheating, the
IR LEDs flash in dark environments before the camera activates. After the camera
activates, the IR LEDs light up constantly.
• Program the camera as described in chapter 12. "Setting up and programming the camera".
• Set the TEST OFF CAM PSET switch to CAM or PSET.
• Press the PRE-TAKE button (16). The LC display shows "+".
• After approx. 30 seconds, the countdown starts and the blue test LED flashes for approx.
60 seconds. Leave the detection area.
• After the 60-second countdown. the camera switches to ready mode, as programmed, but
without time-out periods.
54