Xenteq LBC 500XTR Gebrauchsanweisung Seite 16

OPEN SEMI-TRACTION, TRACTION
WITH COMPENSATION CHARGE
GEL, AGM¹
GEL, AGM¹
WITH COMPENSATION CHARGE
CALCIUM, AGM², SPIRAL
CALCIUM, AGM², SPIRAL
WITH COMPENSATION CHARGE
LiFe-PO4
The charger will leave the setup-mode if the button isn't used for 10 seconds. In this
case the ' power' LED will flash two times. The chosen setting will remain in the
memory of the charger and the setting LED lights when the charger is on.
Charger as power supply
The LBC 500XTR has a special setting for the use as a power supply. In this case the
charger will give one, constant voltage. The users can be connected to the charger
directly, so without intervention of a battery.
Put the charger in its set up mode, as described above. Push until all 4 setting LED's
are out.
POWER SUPPLY
If the charger is in its power supply function, the three charge status LED's are used
to indicate the height of the load. This way you know how much power the charger
supplies.
LED
Green, flashes
Green
Green + yellow
Yellow
Yellow + red
Red
Red, flashes
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3
1 2 3
1 2 3
*= factory setting
1 2 3 4
Current
0%
1% - 20%
21% - 40%
41% - 60%
61% - 80%
81% - 100%
> 100%
EN
(flashing)
(flashing)
4
4
(flashing)
4
16