Xenteq LBC 500XTR Gebrauchsanweisung Seite 12

I N T R O D U C T I O N
On the last pages you will find the technical specifications of the LBC 500XTR series.
Charging status
2 functions:
Overview charge setting
-
Overview type of error
-
at request
The LBC 500XTR is a fully automatic battery charger and float charger in one and can
be left connected to the mains power supply permanently. The micro processor
supervises the battery and the charge process continuously so that a very safe and
accurate process can be guaranteed. The internal electronics comes from the latest
developments, which resulted in a exceptionally intelligent battery charger. The closed
housing is IP 66 classified. The charger is therefore protected against dust, dirt,
vibrations and in a large degree also against moisture.
The LBC 500XTR can be used for a large diversity of battery types, such as Starting,
semi-traction, traction, GEL, AGM, Calcium, Spiral and LifoPo4. The charger is suitable
for many battery types because the charge voltages can be set. See chapter 'SETTING
THE CHARGER', section 'charge voltages'.
During the charge process, and also when the charger is in its float stage, potential
users may be turned on. The charger will indirectly supply the present consumers and
the battery is spared. Keep in mind that when charging a (partially) empty battery,
the current draw of the present consumers comes at the expense of the charge
current for the battery. If you only want to use the charger as a power supply, then
put the charger in its power supply mode, see chapter 'SETTING THE CHARGER'
section 'charger as power supply'.
You can use multiple power sources, like solar panels or a dynamo, together with the
LBC 500XTR battery charger.
Charger status
3 functions:
Setting the charger
Turning charger on/off
Request error
Connection to battery
EN
12