Heatscope MHS-SM1600 Gebrauchsanleitung Seite 37

A M B I E N T H E A T I N G S O L U T I O N S
of temperature and weather protection shields. In the case of a deviant installation setting without
approval of the manufacturer danger for people and environment occurs. Warranty and guarantee
expires for all heaters, which are not installed according to this operation and installation manual!
Other protective measures may need to be taken in accordance with local fire safety regulations, e.g.
for installation on cumbustible surfaces.
All cables must be positioned so that they cannot come into contact with the radiant heater at any
time. The radiant heater must not be installed directly below a power socket. The sides of the HEAT-
SCOPE® must be at least 20 cm from any power sockets.
Care, maintenance and service
Before cleaning and maintaining your HEATSCOPE®, disconnect it from the power supply or, if buried
cables are used, switch it off via the omnipolar switch. Ensure that the unit has cooled down – wait at
least 30 minutes after the last use before you start cleaning it.
All surfaces should be cleaned using a damp cloth only. Never use cleaning products containing alkali-
ne substances such as sodium hydroxide or soap, surfactants or solvents such as alcohol.
Use only a very soft cloth or a brush for the reflector and the heating elements.
Removal from service / disposal
When the unit reaches the end of its life, it must be removed from service by a specialist in accordance
with the relevant regulations and steps must be taken to ensure that it cannot be put into use again.
The unit must be disposed of professionally and in an environmentally friendly manner. The relevant
legal regulations must be observed.
EN
Tel.: +49 8104 647090 · Fax: +49 8104 647099 · E-Mail: mail@munich-home-systems.de · www.munich-home-systems.de