Heatscope MHS-SM1600 Gebrauchsanleitung Seite 32

M U N I C H H O M E S Y S T E M S
an environment with high humidity, the switches or other operating components
must be positioned in such a way that they cannot be touched by persons who are in
direct contact with water. Bathroom heaters must not be operated with a separate
automatic thermostat or timer. When a radiant heater is installed in a bathroom, the
CE standard requires that at least one heating element visibly „glows" as soon as the
unit is switched on.
15. Disconnect the radiant heater from the power supply before cleaning it, adjus-
ting the angle or removing it from the wall/ceiling. Wait until the heating elements
are not glowing any more and the housing is noticably cooled down. If buried cables
are used, switch off the power using an omnipolar switch. Wait at least 30 minutes
after the last use before you start cleaning it. All surfaces should be cleaned using a
damp cloth only. Never use cleaning products containing alkaline substances such as
sodium hydroxide or soap, surfactants or solvents such as alcohol. Use only a very
soft cloth or a brush for the reflector and the heating elements.
16. Always remember to switch off the unit after use.
EN
MHS Munich Home Systems GmbH · Kramergasse 32 · 82054 Sauerlach · Germany