Heatscope MHS-SM1600 Gebrauchsanleitung Seite 29

A M B I E N T H E A T I N G S O L U T I O N S
If the unit or accessories show signs of defects, cracking, breakage or other damage
or if the industrial glass ceramics screen is damaged, discontinue use and have them
repaired. In this case, disconnect the unit from the power supply, return it to the
manufacturer or dispose of it. The unit should be labelled accordingly to prevent it
being reconnected.
2. For installation use only the supplied accessories or original accessories approved
by the manufacturer. The power cable or other components of the HEATSCOPE®
radiant heater may only be replaced by a professional servicing company enlisted by
the manufacturer.
The supply cable must be connected generally in a commercially available wet room
distribution box with IP65 protection class acc. to IEC or UL / CSA (not within the
scope of supply).
3. The HEATSCOPE® is protected against splashing water and has an IP44 protection
class rating (model VISION) resp. IP24 (model SPOT). Nevertheless, it is mandatory to
install the unit on a surface where it is well protected from any weather influences
like rain and dust from above; so the HEATSCOPE® has to be installed under a roof, an
overhang or in combionation with the optional available weather shield.
4. As soon as the unit is connected to a power source and switched on using an „ON/
OFF" switch or other operating component, it takes a maximum of 15-30 seconds
until it reaches its operating temperature.
5. CAUTION: Risk of burns! The front screen (approx. 300°C) and protective fin front
(approx. 300°C) gets very hot when the unit is operating.
Do not cover either part of the front or the entire front of the radiant heater. Do
not touch any part of the HEATSCOPE® during operation and up to 30 minutes after
switching it off.
6. For your own safety, never dry textiles or other materials using the HEATSCOPE®.
Covering the radiant heater may result in a fire! Always maintain a distance from the
heating surface of the HEATSCOPE® of at least 150 cm from textiles, cloth and other
easy inflammable soft materials.
7. Ensure that cables, furniture, flammable materials or other objects do not come
into contact with the surface of the radiant heater and never cover the unit. Under
no circumstances should the unit be covered or enclosed with insulating or similar
materials. Adequate ventilation surrounding the heater must be ensured at any time.
Ledgers, beams and rafters must not be cut into or grooved to install the infrared
heater.
EN
Tel.: +49 8104 647090 · Fax: +49 8104 647099 · E-Mail: mail@munich-home-systems.de · www.munich-home-systems.de