Heatscope MHS-SM1600 Gebrauchsanleitung Seite 30

M U N I C H H O M E S Y S T E M S
When installing the HEATSCOPE® radiant heater, ensure that the lower edge of the
unit is at least 180 cm from the ground and the safety clearances from the wall and
ceiling set out in this manual are maintained. Always maintain a distance from the
heating surface of the HEATSCOPE® of at least 150 cm from textiles, cloth and other
easy inflammable soft materials.
8. Disconnect the radiant heater from the power supply before cleaning it, adjusting
the angle or removing it from the wall/ceiling. Wait until the heating elements are
not glowing any more and the housing is noticably cooled down. If buried cables are
used, switch off the power using an omnipolar switch.
9. The HEATSCOPE® features an omnipolar „ON/OFF" switch. The unit can be cont-
rolled manually either using an IR remote control (supplied, depending on the mo-
del) or a selector switch on the unit itself (depending on the model as well). The unit
must be connected to a residual current circuit breaker and a fuse on the installation
side.
10. The unit must only be used with an approved isolating system, which must be
built in the existing electrical installation acc. to the facility regulations. The heater
comes as standard with a separate open-ended cable for connection purposes.
11. The power cable or buried cable with omnipolar switch may only be replaced
by a professional specialist electrical company enlisted or approved by the manu-
facturer. Heating elements, other components or parts of the housing may only be
replaced by a service organisation enlisted by the manufacturer.
If you yourself or someone enlisted by you carries out repairs, they will not be co-
vered by the guarantee. Improper repairs and incorrect installation or operation shall
invalidate the guarantee immediately.
12. If the heater was installed inappropriately or was connected unhomogeneously
with the local electrical supply cable, high transfer resistances may occur, which lead
to overheating of the device. For the heating system and many custom applications
the heaters were equipped with a NTC temperature control and an additional lat-
ching temperature limiter.
Ordinarily possible over heating due to inappropriate installation is protected by the
NTC temperature control and the latching temperature limiter. If overheating of a
carbon heating element occur due to interlinkage of mounting and installation mis-
takes, the carbon filaments inside of the quarz tubes will fuse and safely disconnect
the current flow. Even after a mechanical break of the quarz tubes, the carbon hea-
ting spirals will not work any longer. Besides the fin front screen of the SPOT heaters
EN
MHS Munich Home Systems GmbH · Kramergasse 32 · 82054 Sauerlach · Germany