Victron energy Phoenix Multi 12/2000/100 Installationsanleitung Seite 49

2.4 Instellingen wijzigen met VEConfigure software
Alle instellingen kunnen gewijzigd worden met VEConfigure software
U kunt de VEConfigure software downloaden van www.victronenergy.com
De volgende instellingen kunnen uitsluitend met VEConfigure gewijzigd worden:
- Ground relay (alleen Multi/MultPlus, standaard: on). When running on inverter the
output neutral is connected to the output ground wire and therefore also the chassis. This is
to ensure proper functioning of a GFCI (Ground Fault Circuit Interrupter), to be installed on
the AC output of the MultiPlus. In an isolated system the ground relay should be disabled.
Proper isolation of both phase and neutral from ground should then be monitored with an
isolation watch system.
- Dynamic current limit (default: off). Some modern AC generators use a static inverter to
generate the AC output. Some of these generators also reduce rpm when operating with
reduced load. By enabling the Dynamic Current Limit function (VEConfigure) the MultiPlus
can be used to assist the generator when suddenly a high load is connected.
- Alarm Relay / Virtual Switch (default: disabled)
A programmable relay is available in both the Phoenix Inverter and Multi/MultiPlus. This
relay can be used for remote alarm and other purposes (a. o. generator start signal). The
relay can be programmed with VEConfigure.
- Frequentie van de AC ingang: zie paragraaf 2.3.4.
2.5 Onderhoud
De Phoenix Multi vereist geen specifiek onderhoud. Het volstaat alle verbindingen eenmaal
per jaar te controleren. Voorkom dat de Phoenix Multi vocht en olie/roet dampen en houd
het apparaat schoon.
21