Clear Cmos Jumper; Table 4-30: At/Atx Mode Selection; Table 4-31: Clear Cmos Jumper Settings - IEI Technology IQ7-US15W Bedienungsanleitung

SW5 Description
1-On AT mode
1-Off ATX mode

Table 4-30: AT/ATX Mode Selection

4.4.2 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
If the IQ7 Design Guide fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, use the
jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to
pins 1 and 2.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
Pin Description
1-2 Keep CMOS Setup
2-3 Clear CMOS Setup

Table 4-31: Clear CMOS Jumper Settings

Page 64
JP8
3-pin header
See Table 4-31
See Figure 4–29
T able 4-31.
5
IQ7 Design Guide