At/Atx Mode Selection; Figure 4-29: Jumpers; Table 4-29: At/Atx Mode Selection - IEI Technology IQ7-US15W Bedienungsanleitung

IQ7 Design Guide
Figure 4–29: Jumpers

4.4.1 AT/ATX Mode Selection

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Set both of the jumpers select AT or ATX power mode for the IQ7 Design Guide. AT
power mode limits the system to on/off. ATX allows the system to use various power
saving states and enter a standby state, so the system can be turned on remotely over a
network. The settings on both jumpers should be the same.
JP8 Description
1-2 ATX mode
3-4 AT mode
5-6 No function

Table 4-29: AT/ATX Mode Selection

JP8 & SW5
6-pin header & switch
See T able 4-29 & Table 4-30
5
See Figure 4–29
Page 63