Umper Settings; Table 4-28: Jumpers - IEI Technology IQ7-US15W Bedienungsanleitung

4.4 Jumper Settings
NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the IQ7 Design Guide is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the IQ7 Design Guide are
listed in T able 4-28.
5
Description
AT/ATX mode selection
Clear CMOS
CompactFlash® Master/Slave
CompactFlash® voltage
LAN & PCIe enable/disable
TTL voltage selection
SATA & graphics settings
TTL enable/disable

Table 4-28: Jumpers

Page 62
Label Type
JP8 & SW5 6-pin header & switch
JP6 3-pin header
JP4 3-pin header
JP3 3-pin header
SW3 Switch
J_VLVDS1 3-pin header
SW4 Switch
SW5 Switch
IQ7 Design Guide