Emptying The Fresh Water Tank - Kärcher BR/BD 530 BAT Bedienungsanleitung

Lower the vacuum bar
Turn the lever downwards; the vacuum
bar is lowered.
Switch on the suction turbine using the
switch.
Switching on the cleaning head
Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Switch on the button for brush opera-
tions.
Activate the control handle; the brush
motor starts up.
Note
First turn on the switch for brush operation,
then use the control handle. If you do this in
reverse order, there will an error message
on the display.
Shutting Down the Appliance
Close the water quantity regulator.
Drive the appliance forward for another
1-2 m to draw off residual water.
Release the control handle.
Switch off the button for brush opera-
tions and suction turbine
Raise the vacuum bar.
Tilt the chassis downward and lock it.
Caution
Danger of deformation of the brush(es).
When shutting down the appliance relieve
the brush(es) by lowering the running gear.
Emptying the Dirt Water Reservoir
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
Take the dirt water discharge hose from
the support and lower above a suited
collection device.
Let off water by opening the dosage de-
vice at the discharge hose.
The rinse the dirt water reservoir with
clear water.

Emptying the Fresh Water Tank

Open the lock of the fresh water tank
using a suitable tool (such as a coin).
– 9
EN 27