9�4�2 Setting Of The Damping Of The Measured Signal; 9�4�3 Reset All Parameters To Factory Setting; 9�4�4 Display Of The Software Version Number; Operation - autosen AL001 Bedienungsanleitung

9.4.2 Setting of the damping of the measured signal
► Select [EF]�
► Press [SET] to change to the menu [EF]�
► Select [dAP]�
► Set the parameter value with [SET]:
Setting range [s]: 0�0���1�0���5�0�
► Confirm with [MODE/ENTER]�
9.4.3 Reset all parameters to factory setting
► Select [EF]�
► Press [SET] to change to the menu [EF]�
► Select [rES], then press [SET] and keep it pressed until [----] is
displayed�
► Confirm with [MODE/ENTER]�
> The unit changes to the Run mode�
9.4.4 Display of the software version number
► Select [EF]�
► Press [SET] to change to the menu [EF]�
► Select [SW], then press [SET]�
> The software version number is displayed�
► Press [MODE/ENTER] to return to the menu [EF]�

10 Operation

10.1 Set-up
► After installation, electrical connection and programming, check whether the
unit operates correctly�
> If the unit has been correctly set up, the distance to the object is indicated�
Lifetime of a laser diode: 50000 hours�
10.1.1 Error indications
Display Possible
Cause
too much light,
[++]
e�g� reflective
surface
Switching output
[Hno] [Hnc] [Fno] [Fnc] [ASP] < [AEP] [ASP] > [AEP]
ON OFF OFF
Current output /
voltage output
ON 3�5 mA / 0 V
UK
20�5 mA / 10 V
49