9�3 Teach Mode; 9�3�1 Setting Of The Sampling Rate; 9�3�2 Setting Of The Repeatability - autosen AL001 Bedienungsanleitung

9.3 Teach mode
9.3.1 Setting of the sampling rate
The sampling rate indicates the maximum time after which a new result of
measurement is provided and the outputs are updated�
The switching frequency is typ� approx� 1/3 of the sampling rate�
► Select [TEAC], then press [SET] and keep pressed until [WAIT] is
displayed�
> [rATE] and [rEPr] are displayed alternately�
► When [rATE] is displayed: press [SET] until the preset sampling rate
value flashes�
► Enter a value incrementally by pressing [SET] once�
► Confirm with [MODE/ENTER]�
> [WAIT] is displayed while the repeatability [rEPr] is calculated�
> The sampling rate [rATE] and repeatability [rEPr] are displayed
alternately�
9.3.2 Setting of the repeatability
► Select [TEAC], then press [SET] and keep pressed until [WAIT] is
displayed�
> [rATE] and [rEPr] are displayed alternately�
► When [rEPr] is displayed: press [SET] until the preset repeatability
value flashes�
► Enter a value incrementally by pressing [SET] once�
► Confirm with [MODE/ENTER]�
> [WAIT] is displayed while the sampling rate [rATE] is calculated�
> The sampling rate [rATE] and repeatability [rEPr] are displayed
alternately�
UK
47