Electrical Connection - Fagor LF 020 SX Installationsanleitung Und Bedienungsanl

The hose must run bet-
b
ween the wall and the
bottom space at the
back of the dishwasher
(b1) so that it is not
squashed or overstret-
ched.
There should be a fixed
water outlet drain at a dis-
tance of between 25 and
100 cm from the floor.
Make sure that the outlet
pipe is not too rigid, bent
or squashed.
I M P O R TA N T
It is very important for the bend pipe of the outlet hose is located securely in water outlet so that
it cannot disconnet. The operating water pressure (minimum and maximum) must be between
0.5-10 bar (0.05-1 megapascals MPa).
3

ELECTRICAL CONNECTION

Please refer to the specifica-
tion label on the top edge
of the door before making
the electrical connections.
Make sure that the power
voltage connected to the
plug socket is as shown on
the label.
I M P O R TA N T
It is very important for the dishwasher to be connected to an earthed plug
socket. The electrical installation, plug, socket, fuses or circuit breaker and
meter must be capable of the maximum power shown on the specifications
label. If the power cable is damaged, it must be replaced exclusively by
the manufacturers, after-sales service (TAS) or authorised personnel. If
the appliance is to be recess-mounted and integrated, the plug must be
accessible after installation.
b1
max.
100 cm
min.
25 cm
b2
If your dishwasher has a
hot water inlet, connect the
pipe to the hot water tap.
In this case, the maxi-
mum temperature must
not exceed 60ºC. Bear in
mind that this type of water
supply may affect the was-
hing and drying capacity
of the appliance.