Electrical Connection - Fagor LF-020 SX Installations- Und Bedienungsanleitung

All manuals and user guides at all-guides.com
The hose must run
b
between the wall and
the bottom space at the
back of the dishwasher
(b1) so that it is not
squashed or
overstretched.
There should be a fixed water
outlet drain at a distance of
between 25 and 100 cm from
the floor. Make sure that the
outlet pipe is not too rigid,
bent or squashed.
IMPORTANT
It is very important for the bend pipe of the outlet hose is located securely in water outlet
so that it cannot disconnet. The operating water pressure (minimum and maximum) must
be between 0,5-10 bar (0,05-1 MPa).
3

ELECTRICAL CONNECTION

Please refer to the specification label on the top edge of the door before making the electrical
connections. Make sure that the power voltage connected to the plug socket is as shown
on the label.
It is very important for
the dishwasher to be
connected to an earthed plug
socket. The electrical
installation, plug, socket, fuses
or circuit breaker and meter
must be capable of the
maximum power shown on
the specifications label. If the
power cable is damaged, it
must be replaced exclusively
by the manufacturers,
aftersales service (TAS) or
authorised personnel. If the
appliance is to be
recessmounted and integrated,
the plug must be accessible
after installation.
b1
max.
100 cm
min.
25 cm
IMPORTANT
The specifications label is on the top edge of the interior
of the door. This label must never be removed, since it
provides information about the exact model of the
dishwasher, required power supply, serial number and
warranty.
English
b2
If your dishwasher has a hot
water inlet, connect the pipe
to the hot water tap. In this
case, the maximum
temperature must not
exceed 60ºC. Bear in
mind that this type of water
supply may affect the
washing and drying
capacity of the appliance.
Serial
number
Model
53